snowblower
Dec. 22nd, 2003 08:30 pm![[personal profile]](https://www.dreamwidth.org/img/silk/identity/user.png){kind=small}
solipsistnationThe snowblower works again.
Were I to be in the market for a new snowblower, I would definitely not even consider another Toro.
Consider, for a moment, the single most likely piece of a pull-start snowblower to break, leaving one stranded.
What's that you say? The pullcord?
Well, then, wouldn't one think it a good idea to put the pullcord in someplace easily reachable, so it could easily be replaced?
Why, of course one would!
Except that Toro did not consider this a good plan, and instead put it in such a place that one must remove more than half the bits of the motor, including the gas tank, in order to reach and replace the pullcord.
This took several hours, was very messy, and was an incredible pain in the ass.
It's nice that it works again, but, boy. What a PAIN. Plus the cord is run through the cowling and out through the control panel of the snowblower in such a way that it can't help but be rubbed against a couple of edges, making it more likely that it will wear out more rapidly.
I have seldom been so annoyed by a piece of equipment. I have a great sense of accomplishment at having replaced this myself (and without a manual or any diagrams-- it's actually a very simple machine), but I'd rather it have been much much easier. Actually applying one's brain to design would have made it less of a pain overall.
Were I to be in the market for a new snowblower, I would definitely not even consider another Toro.
Consider, for a moment, the single most likely piece of a pull-start snowblower to break, leaving one stranded.
What's that you say? The pullcord?
Well, then, wouldn't one think it a good idea to put the pullcord in someplace easily reachable, so it could easily be replaced?
Why, of course one would!
Except that Toro did not consider this a good plan, and instead put it in such a place that one must remove more than half the bits of the motor, including the gas tank, in order to reach and replace the pullcord.
This took several hours, was very messy, and was an incredible pain in the ass.
It's nice that it works again, but, boy. What a PAIN. Plus the cord is run through the cowling and out through the control panel of the snowblower in such a way that it can't help but be rubbed against a couple of edges, making it more likely that it will wear out more rapidly.
I have seldom been so annoyed by a piece of equipment. I have a great sense of accomplishment at having replaced this myself (and without a manual or any diagrams-- it's actually a very simple machine), but I'd rather it have been much much easier. Actually applying one's brain to design would have made it less of a pain overall.